Taping and mudding is what turns hung board into a wall. Joints, corners and fasteners are taped and coated in stages so the surface reads as one plane.
Two rooms with identical board can look completely different once taped. Careful bedding of tape, feathered coats and patient sanding are what make joints disappear under paint.
Every joint between sheets and every screw or nail head gets treated. Tape is bedded into a first coat of compound, then successive coats are applied wider and thinner so the joint blends into the surrounding board.
Each coat must dry before the next. Rushing coats traps moisture and leads to cracking or visible seams later, so a proper taping job spans several days even in a small room.
Drywall taping in Ottawa homes has to cope with seasonal framing movement, so tape is fully bedded rather than skimmed on. Inside corners, outside corner bead and butt joints each get their own treatment.
Drywall mudding in Ottawa follows the same patient sequence on every job: a bedding coat, a fill coat and a finish coat, each feathered wider and left to dry before the next.
The industry describes finish levels from 0 to 5. A garage might only need a basic finish; living spaces usually call for a smooth level 4, and critical lighting or gloss paint can justify level 5.
Tell us where the room is, how it is lit and what paint you plan. That determines the finish level, and the finish level drives time and cost.
Cracked tape, ridged seams and popping fasteners are common in Ottawa homes as framing moves with the seasons. Re-taping the joint properly is more durable than filling the crack with compound alone.
Clear expectations. A considered plan.
A finish that brings the room together.
Room sizes, ceiling heights, photos and any drawings — and whether framing, electrical, plumbing and insulation are finished.
Agree on board types (standard, moisture-resistant, fire-rated or acoustic), the finish level and what is excluded from the scope.
Sheets are hung to minimise joints, fastened, then taped and finished in coats with drying time between them.
Check the surfaces together under normal lighting and settle any touch-ups before the space goes to primer and paint.
A closer look at each type of project. See all projects.
Tell us what needs doing and where. Prefer to talk? Call (613) 319-4768.
Yes. If the board is hung well — tight joints, correct fastening, no major gaps — we can take over at the taping stage. We will flag any boarding issues that would show through the finish first.
Typically three or more coats over the tape, plus work on fasteners and corners, with drying time between coats. The exact number depends on the finish level you want.
Seasonal movement of framing, poor original bedding of the tape, or too little compound. Re-taping addresses the cause; skimming over the crack usually does not last.
Coats are smoothed as they are applied and sanded at the end. Sanding creates fine dust, so ask about containment and cleanup if you are living in the home during the work.
Tell us what you have in mind. Let’s talk about your drywall project.
